Reduce individual sensor sensitivity if necessary (the AccelSens and GyroSense, in the Motion section, where 100 is 100% sensitivity) in configuration file.Reduce the general sensitivity if necessary (the Sens parameter, in the Motion section, where 100 is 100% sensitivity) in configuration file. Install FreePieIMU on your Android phone by taking the latest version in the OpenTrack archive or in the releases, enter the IP address of your computer, select "Send raw data", if not selected, select the data rate "Fastest" or "Fast".Check Windows Firewall to see if incoming connections are allowed on your network type (private) and allow if disabled.You can use swipes for the keyboard, the button codes are described below. By default, pressing the touchpad during swipes is disabled, it can be enabled in the configuration file by changing the TouchPadPressedWhenSwiping parameter to 1. On the Xbox gamepad, you need to press the "Back/View/Select" button (touchpad) and move the stick to the sides for swipes. Options -> Accessibility -> "Strumming Settings" instead of vertical and horizontal, put buttons. The "Share" button (F12) duplicates pressing the left side of the touchpad. Press "ALT" + "F9" to get the values, paste them into the "Config.ini" configuration file, into the DeadZone parameters and restart the program. If necessary, you can swap bumpers and triggers, as well as the "share" button and pressing the touchpad, to do this change the SwapTriggersShoulders or SwapShareTouchPad parameter to 1 in the "Config.ini" configuration file.Ĭhanging the dead zone of sticks for drifting sticks is supported. You can shake (gyro) the controller by pressing "Back/View/Select" and "RB" (right bumper). Also, the "PS" button is tied to the simultaneous pressing of the "Back/View/Select" and "LB" buttons (left bumper) or the "F2" key. The "PS" button is binded to the "Xbox" button, but to use it, you need to disable the use of this button in the "Xbox Game Bar" settings. The "PS Share" button is binded to the simultaneous pressing of the "Back/View/Select" and "Start/Menu" buttons or to the "F12" key. The "Back/View/Select" button (the first button to the right of the left stick) on the Xbox controller emulating pressing the touchpad on a Sony DualShock 4. Next, go to the xCloud website, press "F12", select the console and paste this code there, press run and the context menu will no longer be shown.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |